ADJUSTABLE AIRBED ASSEMBLY INSTRUCTIONS
NO TOOLS REQUIRED
1. Read instructions completely.
2. You may assemble your entire system before placing it on your foundation or platform base.
3. Unfold the cover, quilted side up and unzip to remove the top of the cover. Inside you will find the air mattress with the inflator attached to each one. Center air mattress with auto-inflator facing out toward the inside of the cover side.
3a. AIR HYBRID WITH DUAL CHAMBER: Unfold the cover, quilted side up and unzip to remove the top of the cover. Inside you will find two air mattresses with an inflator attached to each one. Center the two mattresses side by side in the cover. The inflators should be facing out toward the inside of the cover side.
4. Plug in the inflator(s) power cord(s) into any standard 120 volt outlet, 50/60 Hz.
PUMP OPERATION (HOUSEHOLD USE ONLY):
a. Plug pump into 120 V outlet
b. Press switch on hand control to soft, to release air from mattress
c. Press switch to firm to increase air in mattress
5. Inflate the air mattress until soft, using the auto-inflator control.
6. Taking the two short foam rails, place them inside the cover between the air mattress and the long side of the cover at the head and foot.
7. Take the two long foam rails and place them in the cover between the head and foot rails. The side rail is cut out to accommodate the inflator which fits into this cut out.
8. The following point pertains to the Royal Celestial and the Royal Supreme only: Take the finger foam comfort pad wrapped in sensi-touch vinyl and place it over the air mattress and foam rails. The foam fingers should be facing up. Do not remove the foam from the vinyl. The viny protects the foam from body vapors and prolongs the life of your bed.
9. Replace the top of the cover and zip the cover closed. Place the mattress in its permanent location.
10. Now enjoy your bed. Lie in your natural sleeping position. Then using the auto-inflator control, adjust to your personal comfort level.
* To service inflator or mattress the units may be separated from each other by extending fill valve and loosening the clamp.